Alerts and notices

For drawers that are designated as contributors to Digita NetClient, you can set up Digita FileCabinet to transmit the contents of specified folders to Digita NetClient . For example, if you create a document folder called "Portal documents," you can designate the contents of that folder for transmission to Digita NetClient for all Digita NetClient-enabled drawers.

You can also choose application folders for transmission to Digita NetClient. All documents contained in those folders for Digita NetClient-enabled drawers will be transmitted to Digita NetClient during the next call to Digita Connect.

Use the following procedure to set up Digita FileCabinet to transmit the contents of specified folders to Digita NetClient.

1. Choose Setup > System Configuration.
2. Click the Digita NetClient tab.
3. Mark the checkbox for each document and/or application folder you wish to designate for transmission to Digita NetStaff or Digita NetClient.
4. Click OK.

The Digita NetClient folder designation is a global setting. If you enable a folder using this procedure, that folder is enabled for every drawer that is designated as a contributor to Digita NetClient.

Was this article helpful?

Yes No

Submit